本文件彙總了一些ThinkPad在開機時會出現的報錯資訊。

LiuXiaolong0624發表於2024-08-21

故障現象 ThinkPad在開機時常見的報錯資訊及含義。
0177
Bad SVP data, stop POST task—The checksum of the
supervisor password in the EEPROM is not correct。
System board。主機板問題。

0183
Bad CRC of Security Settings in EFI Variable。 Enter the
ThinkPad Setup program。
1、Run the ThinkPad Setup program, and then save
current setting by pressing F10。進入BIOS,F10儲存退出 。
2、System board。主機板問題。

0187
EAIA data access error—The access to EEPROM is failed。
System board。主機板問題。

0188
Invalid RFID Serialization Information Area
System board。主機板問題。

0189
Invalid RFID configuration information area—The
EEPROM checksum is not correct。
System board。主機板問題。

0190
Critical low-battery error
1、 Charge the battery pack。給電池充電。
2、 Battery pack。 電池問題。

0191
System Security—Invalid Remote Change requested。
1、Run the ThinkPad Setup program, and then save
current setting by pressing F10。 進入BIOS,F10儲存退出。
2、System board。主機板問題。

0199
System Security— Security password retry count exceeded。
1、Run the ThinkPad Setup program, and then save
the current setting by pressing F10。進入BIOS,F10 儲存退出。
2、System board 主機板問題。

0251
System CMOS checksum bad - Default configuration
used。
1、Charge the backup battery for more than 8 hours
by connecting the ac adapter。連線電源介面卡至少充電8小時。
2、Replace the backup battery and run ThinkPad Setup
to reset the time and date。 更換CMOS電池。

0253
EFI Variable Block Data was destroyed。

0271
Real-Time Clock Error。 Check Date and Time settings。
Run ThinkPad Setup to reset the time and date。進入BIOS充值時間日期。

1802
Unauthorized network card is plugged in—Turn off and
remove the miniPCI network card。
1、Remove Mini PCI network card。移除迷你PCI網路卡裝置。
2、System board。 主機板問題。

1820
More than one external fingerprint reader is attached。
Power off and remove all but the reader that you set up
within your main operating system。
Remove all but the reader that you set up for the
authentication。移除其他外接裝置再嘗試設定。

2000
ThinkVantage Active Protection sensor diagnostics
failed。
System board。主機板問題。

2100
Detection error on HDD0 (Main HDD)
1、Reseat the hard disk drive。重新插拔下硬碟。
2、Main hard disk drive。主硬碟問題。
3、System board。 主機板問題。

2101
Detection error on HDD1 (Ultrabay HDD)
1、Reseat the hard disk drive。重新插拔下硬碟。
2、Ultrabay hard disk drive。 第二塊硬碟的問題。
3、System board。 主機板問題。

2102
Detection error on HDD2 (Mini SATA)
1、Reseat the Mini SATA device。重新插拔下硬碟。
2、Mini SATA device。 第三塊硬碟的問題。
3、System board。 主機板問題。

2110
Read error on HDD0 (Main HDD)
1、Reseat the hard disk drive。重新拔插下硬碟。
2、Main hard disk drive。 主硬碟問題。
3、System board。 主機板問題。

2111
Read error on HDD1 (Ultrabay HDD)
1、Reseat the hard disk drive。 重新拔插下硬碟。
2、Ultrabay hard disk drive。 第二塊硬碟的問題。
3、System board。 主機板問題。

2112
Read error on HDD2 (Mini SATA)
1、Reseat the Mini SATA device。重新拔插下硬碟。
2、Mini SATA device。 第三塊硬碟的問題。
3、System board。 主機板問題。

2200
Machine Type and Serial Number are invalid。
System board。 主機板問題。

2201
Machine UUID is invalid
System board。主機板問題。

Fan error。
1、Fan。 風扇問題。
2、Thermal grease。導熱劑的問題。
3、System board。 主機板問題。

Thermal sensing error。 System board。主機板問題。
The battery installed is not supported by this system
and will not charge。 Please replace the battery with the
correct Lenovo battery for this system。 Press the ESC
key to continue。
Replace the battery。更換電池。

相關文章