DFL裝置對ST300DM1001-1CH166部分扇區無法訪問資料的恢復步驟

This is one successful remote data recovery case study for one DFL user in USA.

這是 一個美國 DFL 使用者的遠端資料恢復 成功案例 。

 

According to the user’s report, the patient drive could be properly detected and was able to enter F3 T> but when he tried to image the hard drive, he could only image 70% around of the drive and the last 30% of data was blocked. If the user tried to scan the bad sectors, full of bad sectors was found.

根據使用者的報告， 故障硬碟 可以被正確地檢測並能夠進入 F3T> ，但當他 嘗試 對硬碟進行 映象 時，他只能 映象硬碟的 70% ，而最後 30% 的資料 卻無法繼續映象 。如果使用者試圖掃描壞扇區，就會發現滿是壞扇區。

 

The very first thing was to backup the rom, translator, primary defect lists and NG-list and next users tried the DFL auto partial sector access solution, but no bad sectors were found and the log windows reported translator restoration success. That is to say, the problem of the last 30% problem was caused by some other issue.

開始操作時的 第一件事是備份 ROM 、 編譯 器、主要缺陷表和 NG 表，下 一步 使用者嘗 試 DFL 部分扇區訪問自動解決方案 ，但是沒有發現壞扇區，日誌視窗報告 顯示編譯 器恢復成功。也就是說，最後 30% 的問題是由一些其他的問題造成的。

 

Engineer checked the NG list contents and found some entries inside and next, the engineer fixed NG list with DFL Seagate firmware repair tool, clear defect lists, reset smart and then regenerated translator, power off and on, the drive was perfectly fixed and the last 30% of data was accessible too.

工程師檢查了 NG 表內容和發現一些 列表 ，接下來，工程師 使用 DFL 希捷韌體修復工具 修復 NG 表， 清除 缺陷表，重置 SMART 然後再生 成譯碼錶 ， 重啟 電源，硬碟 完美恢復 最後的百分之三十的資料訪問

 

This partial sector access problem for ST3000DM001-1CH166 was fixed within two minutes and the user could finally recover 100% of the data with DFL-DDP data recovery program.

ST300DM1001-1CH166 的部分扇區無法映象的問題在兩分鐘內完美修復，使用者最終可以用 DFL — DDP 資料恢復程式恢復 100% 的資料。