BIP2087E: Broker BrokerDemo was unable to process the internal configuration mes

今天部署的時候,.出現下面這個錯誤,

BIP4041E：執行組'預設'發現一個無效的配置資訊。

BIP2210E：無效的配置資訊：屬性名稱'allowQueryWSDL'不為目標物件的有效'Main.TestMessageFlows。'

 
Begin running task [Deploying [BrokerDemo.bar] to execution group [default]]

BIP2087E: Broker BrokerDemo was unable to process the internal configuration message.

The entire internal configuration message failed to be processed successfully.

Use the messages following this message to determine the reasons for the failure. If the problem cannot be resolved after reviewing these messages, contact your IBM Support center. Enabling service trace may help determine the cause of the failure.

BIP4041E: Execution group 'default' received an invalid configuration message. See the following messages for details of the error.

The broker was asked to deploy a message flow which contained properties that were not recognized by the broker. This typically results from a message flow requiring a version or type of node that is not supported by the broker installation.

Check that the message flow is only using properties or nodes that are supported on the broker. Check that all necessary user-defined extensions are installed and that they are of a version that is compatible with the message flow.

BIP2210E: Invalid configuration message: attribute name 'allowQueryWSDL' not valid for target object 'Main.OperationReadinessServiceToHCDM.'.

The message broker received a configuration message containing the attribute name 'allowQueryWSDL' which is not valid for the target object 'Main.OperationReadinessServiceToHCDM.'.  This can be caused by a mismatch in levels between the Message Broker Toolkit and the broker, or as a result of a user or third party written user-defined node where the implementation library installed at the broker does not match the node definition held at the Message Broker Toolkit.

Ensure that the levels of code installed at the Message Broker Toolkit and broker are consistent.  If they are, identify the supplier of the target object and report the problem to them.  If this is IBM, contact your IBM support center.

The task was unsuccessful: The deployment was unsuccessful. Check error messages above for explanation.

 

解決方案：

 

1.找到主流程,檢查一下整個的流程.時候有編譯錯誤.

 

2.找到SOAP Input節點右擊->選擇Properties->HTTP Transport中的 ->Enable Sopor For ?wsdl.去掉核取方塊中的選項.即可。